FW3-B48-LAB-K BLiNQ FW-300i Lab / Trial Kit- Complete Kit

BLiNQ FW-300i Lab / Trial Kit

BLiNQ FW-300i Lab / Trial Kit

SKU
FW3-B48-LAB-K
Availability: In stock - Direct ship from New Jersey.
Kit started with this Lab/ Trial Kit from BLiNQ Networks. Everything you need to get your FW-300i setup up and running!

Limited to 1 kit per customer, while supplies last
$7,000.00
Kit Includes
(1) FW-300i B48 Base Unit
(3) FWC-122HG-35 High Gain CPEs
(1) FW3-EPC-LIC Embedded EPC License Key
(3) FWC-SIM-NR1 CPE Sim Cards
(1) FW3-AC-PWR Power Supply

Kit started with this Lab/ Trial Kit from BLiNQ Networks. Everything you need to get your FW-300i setup up and running!

The BLiNQ Networks FW-300i 20MHz LTE CBRS base unit without Embedded EPC Kit 10W Center FCC Bands 48 (without embedded EPC) is a single piece of hardware that is easy to set up, fits anywhere, and provides incredible network capacity. Simply place the FW-300i on the side of a building or water tower and it is ready to go immediately.

FW-300i Features
• Brings massive capacity and standard LTE together
• Lowers installation time and operational cost by up to 6x
• Works with any LTE CPE on the market
• Integrated antennas are built-in for a "cell-in-a-box" solution
• Outperforms competitors in a frequency-2 reuse scenario
• Delivers the best cost per gigabit air capacity in the industry

FW-300i Specifications
• Frequency Band: TDD LTE Bands 48
• Transmit Power (Bands 42, 43) *: Max 33 dBm / sector of 60deg, 17dBi Integrated Antenna 50dBm EIRP/Sector
• Channel Bandwidth: 10, 20MHz (15 MHz Road-map Support)
• MIMO: 6Tx x 6Rx (several possible MIMO configurations)
• LTE Compliance: 3GPP Release 10 (SW upgrade up to Release 13)
• Connected/Active UEs: Up to 96 active users per sector. 288 active users per Box
• Carrier Aggregation: Supports contiguous and non-contiguous 1CC, 2CC, 3CC, over entire band
• Throughput DL TDD: 3GPP Release 10 (SW upgrade to Release 13)
• Throughput UL TDD: 3GPP Release 10 (SW upgrade to Release 13)
• Operating Mode: TD-LTE
• Power: Consumption (Band 46) 80W max.
• Power: Consumption (Band 42,43,48) 150W max.
• Power: 48V DC
• Connectivity: Default: 1 x Copper 1000BaseT & 1 x SFP
• Synchronization Integral GPS receiver (GPS GLONASS BeiDou), Extra PPS Port,
• Optional: External GPS, 1588v2
• CBRS: CBSD Type B SAS Support, Integrated Domain Proxy SAS
• Embedded EPC: Software Option
• Configuration: WebUI / CLI, Radio and Ethernet performance monitoring
• EMS Integration: SNMP v2c/v3
• OAM Protocols: NetConf, HTTP(S), TCP/IP, UDP, (S)FTP, SSH, TR-069/TR-196
• Gain: 17dBi
• Azimuth coverage (-5dB): 180°
• Azimuth Beam-width (-3dB): 45°
• Azimuth Beam-width (-5dB): 60°
• Elevation Beam-width (- 3dB): 10°
• Electrical Down-tilt: 0°
• Azimuth Side-lobe: < -25 dB (Typ.)
• Front-to-Back Ratio @180°: > 30dB (Typ.)
• Co-Polar Port-to-Port Isolation 15dB (Typ.)
• Cross-Polarization Port-to- Port Isolation: > 20dB (Typ.)
• Max. VSWR: 1.5:1
• Polarization: Dual Pol 45°
• Lightning Protection: DC Ground
• Dimensions (LxWxD): 350x570x227 mm (13.78”x 22.4”x 8.9”)
• Survival Wind Speed: > 200 km/hr
• Weight: 12.0 kg
• Operational Temperature: -40 to 60 °C
• Mechanical Up/Down Tilt: 0°, 5°,10°

FWC-122HG-35 Features
• Supports TDD-LTE Mode Band 42, 43 & 48
• Supports 3GPP Release 12 compliant
• Supports up to UE LTE Category 12/13/15 PHY Rate
• Supports 4x4 MIMO with 40MHz CA
• Supports DL 256QAM with DL 2x2 MIMO only up to 80MHz CA
• Supports UL 2Tx (CDD / UL_CA/ UL_MIMO)
• Physical 2Tx & 4Rx in RF front end GPS for location (optional HW & SW; not in default package)
• Supports 1.8V and 3V SIM and USIM card for LTE Mode
• Supports Dynamic Host Configuration Protocol
• Built-in web server for web-based configuration
• Password protected access and configuration
• Supports IEEE 802.3, IEEE 802.3u, 802.3ab (10/100/1000 Mbps )
• Supports Power over Ethernet of Outdoor WAN port {802.3 at}
• Supports VPN pass-through
• IP67 Environmental Proof

FWC-122HG-35 Specifications
• Peak Throughput: DL 440 Mbps (Config 2-7); UL 30 Mbps (Config 2-7)
• Carrier Aggregation:
     • DL 4CC up to 20 MHz each (w. DL 2x2 + 256QAM)
     • DL 2CC up to 20MHz each (w. DL 4x4)
     • UL 2CC or Diversity or TM2 + 6 4 QAM
• Frequency Band: TDD LTE Bands 42, 43, 48
• DL Carrier Aggregation Bandwidth: 80MHz max.
• UL Carrier Aggregation Bandwidth: 40MHz max. with 2 CC
• Transmit Power: Up to +23 dBm
• Tx Power Dynamic Range: 63 dBm
• Receiver Sensitivity: -95 dBm
• Integrated Antenna Peak Gain: 16 ± 1.0 dBi
• Channel Bandwidth: 10, 20 MHz
• MIMO:
     • DL MIMO 2x2 / 4x4 / 8x4
     • UL 1x2 (with div ersity); UL 1x2 CA; UL 2 x2
• LTE Compliance: 3GPP Release 12 (Category 12/13/15 PHY Rate suppor ted)
• CBRS SAS Support: CBRS Type B Client
• PoE: 802.3at
• Survival Wind Speed: 124mph (200km/h)
• Operating Humidity: 5% to 95%
• Storage Humidity: 5% to 95%
• Operational Temperature: -40°F to 131°F (-40°C to 55°C)
• Storage Temperature: -40°F to 158°F (-40°C to 70°C)
• MTBF ODU: 300,000 at 131°F (55°C)
• LTE: EN 301 908-13 V11.1.1
• Safety: EN/UL 60950-1 & EN/UL 60950-22
• EMC: EN 301 489-1 / -4 / -17 / -24
• Environmental: IP67

Product Documentation
BLiNQ Networks FW-300i Data Sheet
BLiNQ Networks FWC-122HG-35 Data Sheet
More Information
SKU FW3-B48-LAB-K
Datasheet https://www.balticnetworks.com/docs/BLiNQ-FW-300i-DS.pdf
Manufacturer BLiNQ Networks
Country of Manufacture United States
Large or Oversize Package No
HTS Code 8517.69.0000
ECCN EAR99
We found other products you might like!